Our Window Installation Process

Quality Products Deserve Quality Installation

Replacing more than one window in your home may sound like a daunting project, but at Door Store and Windows we strive to make the replacement process as simple as possible for the homeowner. One important aspect of this is our efficient rolling installation.

During your window installation, the TDSW team breaks into two groups. Team A begins the installation process on the first window, removing the old and preparing the frame for the new. At the halfway point, team B begins removing the second window and preparing the frame. This way, as soon as team A finishes installing the first new window, the second is ready to be installed. This rolling process guarantees that the project is done quickly and efficiently without leaving your home vulnerable to the elements.

An installation project timeline depends on the number and type of windows you plan to replace. We are proud to say that we complete most of our installation projects in one to two days, causing as little disruption as possible.

Our window installation process consists of the following steps:

1. Team Arrival, Introduction, and Work Space Preparation

Our installation team consists of two to five people, depending on the size of the project. When the team arrives, they introduce themselves before preparing their work space. To contain debris, we place plastic sheeting on the floor and surrounding surfaces in each room. Our team lays a plastic walkway throughout the home so that our team members can carry heavy equipment without affecting your floor. As required by the EPA, we use additional coverage when replacing very old windows which have been covered with lead-based paint.

Plastic sheeting is placed around the window to be removed.

2. Verify Measurement

Before removing any windows, our team makes sure to re-measure the insert area and the new window. This guarantees that the correctly sized product was delivered and that we will be able to complete the project once we begin demolition.

Measuring A Replacement Window

A TDSW Installer measuring the window insert area.

3. Remove Old Window

After measurements are verified, our team carefully removes the first old window, preserving molding and surrounding areas.

The old windows are carefully removed.

4. Clean Insert Area

Once the old window is removed, our team cleans up any loose paint, dust, and other debris from the insert area. At this point in the demolition, you may be able to see inside your wall. This surprises some of our customers, but there’s no need to worry: our team will ensure that there are no signs of demolition once installation is complete.

The insert area is thoroughly cleaned before installation.

5. Installation

Our team carefully unloads the new windows, removes the packaging, and installs the product. Once the window is set and secured, we use spray foam insulation around the perimeter. This creates an energy-efficient seal. Then, we reapply the trim.

A TDSW Installer lifts the new window into place.

6. Clean-Up

After installation we clean up any debris, vacuum the area, and remove the plastic sheeting.

The finished product.

At Door Store and Windows, our goal is to provide peace of mind and customer satisfaction throughout the entire replacement process. Click here to learn more about the replacement process from consultation to install. If you have any questions, feel free to give us a call at (502) 822-5424.

Read about out our door replacement process by clicking here!